Home › BODY ELECTRICAL › LIGHTING › DOME RELAY

DOME RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT DOME RELAY


    E209082
  1. Remove the DOME relay from the No. 2 engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminal 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminal 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the DOME relay.