Home › ENGINE ยท 2KD-FTV › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR WITH CLUTCH PULLEY
  1. Remove the generator pulley cap.



    A115866E01
  1. Install SST to the pulley and vise as shown in the illustration.

    SST
    09820-63020  

  1. Mount SST (A) in a vise.



    A115874E01
  1. Turn SST (B) clockwise, and loosen the pulley.

  1. Remove the pulley.



2. REMOVE GENERATOR REAR END COVER


    A079302
  1. Remove the 3 nuts and generator rear end cover.



3. REMOVE TERMINAL INSULATOR


    A079342
  1. Remove the terminal insulator.



4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A079303
  1. Remove the 2 screws and generator brush holder assembly.



5. REMOVE GENERATOR COIL ASSEMBLY


    A079304
  1. Remove the 4 through bolts.



    A115875E01
  1. Using SST, remove the generator coil.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)

  1. Remove the generator washer.



6. REMOVE GENERATOR ROTOR ASSEMBLY
  1. Remove the generator rotor from the drive end frame.



7. INSPECT GENERATOR DRIVE END FRAME BEARING


    A079307
  1. Inspect than the bearing is not rough or worn. If necessary, replace the bearing.



8. REMOVE GENERATOR DRIVE END FRAME BEARING


    A079311
  1. Remove the 4 screws and bearing retainer.



    A115881E01
  1. Using SST, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)