Home › ENGINE · 2KD-FTV › CHARGING › GENERATOR

GENERATOR > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR DRIVE END FRAME BEARING


    A102672
  1. Using SST and a press, press in a new bearing.

    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)



    A079311E01
  1. Align the claws of the bearing retainer with the grooves inside the drive end frame.

  1. Install the bearing retainer with the 4 screws.



2. INSTALL GENERATOR ROTOR ASSEMBLY
  1. Install the rotor and washer to the drive end frame.



3. INSTALL GENERATOR COIL ASSEMBLY


    A102673E01
  1. Using deep socket wrench (21 mm) and a press, slowly press in the generator coil assembly.



    A079304
  1. Install the generator coil assembly with the 4 through bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }



4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


    A113845E01
  1. While pushing the 2 brushes to the inside of the generator brush holder assembly, insert a φ1.0 mm (0.039 in.) pin into the generator brush holder hole.



    A079303E01
  1. Install the brush holder assembly with the 2 screws.

  1. Pull out the pin from the brush holder assembly.



5. INSTALL TERMINAL INSULATOR


    A079318
  1. Install the terminal insulator.



6. INSTALL GENERATOR REAR END COVER


    A079302
  1. Install the generator rear end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



7. INSTALL GENERATOR WITH CLUTCH PULLEY
  1. Install the pulley by hand.



    A115866E01
  1. Install SST to the pulley and vise as shown in the illustration.

    SST
    09820-63020  



    A113786E01
  1. Turn SST (B) counterclockwise, and tighten the pulley.

    SST
    09820-63020  

    Torque:
    87 N*m{ 891 kgf*cm , 64 ft.*lbf }

    NOTICE:
    Use a torque wrench with a fulcrum length of 380 mm (14.96 in.).

  1. Check that the generator pulley rotates smoothly.

  1. Install the generator pulley cap.