Home › ENGINE ยท 2TR-FE › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE REPAIR SERVICE STARTER KIT


    A101213E01
  1. Remove the nut, and disconnect the lead wire from terminal C.



    A101214
  1. Remove the 2 screws that holds the repair service starter kit from the starter drive housing.

  1. Remove the repair service starter kit.



2. REMOVE STARTER YOKE ASSEMBLY


    A101215
  1. Remove the 2 through bolts, and pull out the starter yoke assembly together with the starter commutator end frame assembly.



3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY
  1. Remove the starter commutator end frame assembly from the starter yoke.



4. REMOVE STARTER ARMATURE PLATE


    A079722
  1. Remove the starter armature plate from the starter yoke.



5. REMOVE STARTER COMMUTATOR END FRAME COVER


    A101216J02
  1. Using a screwdriver, remove the starter commutator end frame cover.



6. REMOVE STARTER ARMATURE ASSEMBLY


    A073993E01
  1. Hold the starter commutator end frame in a vise between aluminum plates.

  1. Using snap ring pliers, remove the snap ring and plate washer.

  1. Remove the starter armature assembly from the commutator end frame.



7. REMOVE PLANET GEAR


    A101217
  1. Remove the 3 planet gears.



8. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
  1. Remove the starter center bearing clutch sub-assembly with the starter drive lever set pin from the starter drive housing.



    A073990
  1. Remove the starter drive lever set pin from the starter center bearing clutch sub-assembly.