Home › ENGINE ยท 2TR-FE › STARTING › STARTER

STARTER > REASSEMBLY

for Preparation Click here



1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    A084665E01
  1. Install the drive lever set pin to the starter center bearing clutch sub-assembly

  1. Install the starter center bearing clutch with the drive lever set pin to the starter drive housing.



2. INSTALL PLANET GEAR


    A101218
  1. Apply grease to the planet gears and pin parts of the planet shaft.

  1. Install the 3 planet gears.



3. INSTALL STARTER ARMATURE ASSEMBLY
  1. Apply grease to the plate washer and armature shaft.

  1. Install the armature shaft to the starter commutator end frame.



    A073993E01
  1. Using snap ring pliers, install the plate washer and a new snap ring.

    NOTICE:
    1. Be sure to install the snap ring in the armature shaft groove securely.
    2. Be sure to properly install the snap ring because it easily expands.



    A058810E01
  1. Using vernier calipers, measure the snap ring.

    Maximum length:
    5.0 mm (0.197 in.)

    If the length is greater than the maximum, replace the snap ring.



4. INSTALL STARTER COMMUTATOR END FRAME COVER


    A102216E01
  1. Install the starter commutator end frame cover to the starter commutator end frame.



5. INSTALL STARTER ARMATURE PLATE


    A073991E01
  1. Align the claw of the armature plate with the groove inside the starter yoke, and install the starter armature plate.



6. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY


    G037250E01
  1. Align the starter commutator end frame rubber with the groove of the starter yoke.

  1. Install the starter commutator end frame to the starter yoke.

    NOTICE:
    The magnet of the starter yoke may attract the starter armature when the starter commutator end frame is installed, causing the magnet break.



7. INSTALL STARTER YOKE ASSEMBLY


    G037251E01
  1. Align the claw of the starter yoke assembly with the groove inside the starter drive housing.



    A101215
  1. Install the starter yoke assembly with the 2 bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



8. INSTALL REPAIR SERVICE STARTER KIT
  1. Apply grease to the plunger and hook.



    A102495
  1. Hang the plunger hook of the repair service starter kit to the drive lever.



    A101214
  1. Install the repair service starter kit with the 2 screws.

    Torque:
    7.5 N*m{ 77 kgf*cm , 66 in.*lbf }



    A101213
  1. Connect the lead wire to terminal C with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }