Home › ENGINE ยท 2TR-FE › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR WITH CLUTCH PULLEY (w/ Clutch Pulley)


    A115867E01
  1. Using a screwdriver, remove the generator pulley cap from the generator with clutch pulley.



    A113834E01
  1. Set SST (A) and (B).

    SST
    09820-63020  

    1. Set the rotor shaft to SST (A).

    2. Mount SST (A) in a vise.



    A102573E01
  1. Install the generator on the SST as shown in the illustration.

  1. Turn SST (B) clockwise, and loosen the generator pulley.

  1. Remove the generator from SST.

  1. Remove the pulley from the rotor shaft.



2. REMOVE GENERATOR PULLEY (w/o Clutch Pulley)


    A075664E01
  1. Hold SST (1-A) with a torque wrench, and tighten SST (1-B) clockwise to the specified torque.

    SST
    09820-63010   (09820-06010, 09820-06020)
    HINT: 
    SST (1-A) and (1-B)
    09820-06010
    SST 2
    09820-06020

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that the SST is secured to the generator rotor shaft.



    A075665E01
  1. Mount SST 2 in a vise.

  1. Insert SST (1-A) and (1-B) into SST 2, and attach the generator pulley nut to SST 2.



    A075666E01
  1. Turn SST (1-A) in the direction shown in the illustration to loosen the generator pulley nut.

    NOTICE:
    Do not loosen the generator pulley nut more than one-half turn to prevent damage to the rotor shaft.

  1. Remove the generator from SST 2.



    A075667E01
  1. Turn SST (1-B), and remove SST (1-A) and (1-B).

  1. Remove the generator pulley nut and generator pulley.



3. REMOVE GENERATOR REAR END COVER


    A102574
  1. Remove the 3 nuts and generator rear end cover.



4. REMOVE TERMINAL INSULATOR


    A102575
  1. Remove the terminal insulator.



5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A102576
  1. Remove the 2 screws and generator brush holder assembly.



6. REMOVE GENERATOR COIL ASSEMBLY


    A102577
  1. Remove the 4 through bolts.



    A115868E01
  1. Using SST, remove the generator coil assembly.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)



7. REMOVE GENERATOR ROTOR ASSEMBLY
  1. Remove the generator washer.

  1. Remove the generator rotor assembly from the generator rear end cover.



8. INSPECT GENERATOR DRIVE END FRAME BEARING


    A102579
  1. Check that the generator drive end frame bearing is not rough or worn.
    If necessary, replace the generator drive end frame bearing.



9. REMOVE GENERATOR DRIVE END FRAME BEARING


    A102580
  1. Remove the 4 screws and bearing retainer.



    A102581E01
  1. Using SST and a hammer, tap out the generator drive end frame bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)