Home › DRIVE LINE › DIFFERENTIAL › DIFFERENTIAL OIL

DIFFERENTIAL OIL > ADJUSTMENT

for Preparation Click here



1. INSPECT AND ADJUST DIFFERENTIAL OIL
  1. Stop the vehicle on a level place.

  1. Remove the differential filler plug and gasket.



    D025304E04
  1. Check that the oil surface is within 5 mm (0.20 in.) of the lowest position of the inner surface of the differential filler plug opening.

    NOTICE:
    1. Excessively large or small amounts of oil may cause trouble.
    2. After replacing oil, drive the vehicle and check the oil level.

    HINT:
    If necessary, fill the rear differential carrier with hypoid gear oil.

  1. Check for oil leakage when the oil level is low.

  1. Install the differential filler plug and a new gasket.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



2. FILL DIFFERENTIAL OIL
  1. Remove the differential filler plug and gasket.

  1. Fill with oil.

    Oil grade:
    Hypoid gear oil API GL-5 or equivalent


    Recommended oil viscosity 
    Above -18°C (0°F)
    SAE 90
    Below -18°C (0°F)
    SAE 80W or 80W-90

  1. Check the oil level.

  1. Install the differential filler plug with a new gasket.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

    NOTICE:
    After replacing the oil, recheck the oil level after driving.