Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID


3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


    C102597E01
  1. Release the parking brake lever, and remove the brake drum.

    HINT:
    If the brake drum cannot be removed easily, perform the following steps.

  1. Remove the hole plug and insert a screwdriver through the hole in the backing plate, and hold the automatic adjusting lever away from the adjuster.

  1. Using another screwdriver, contract the brake shoe adjuster by turning the adjusting wheel.



4. REMOVE REAR AXLE BRAKE DRUM GASKET


5. REMOVE AUTOMATIC ADJUST LEVER


    C102605
  1. Remove the automatic adjust lever and the tension spring.



6. SEPARATE PARKING BRAKE SHOE STRUT SET


    C102599E01
  1. Using SST, remove the upper side tension spring from the brake shoe.

    SST
    09703-30011  



7. REMOVE FRONT BRAKE SHOE


    C102600
  1. Using a needle-nose pliers, remove the anchor side tension spring.



    C102601E01
  1. Using SST, remove the cup, shoe hold-down sprig and pin.

    SST
    09718-00010  



    C102667
  1. Remove the parking brake shoe lower strut.

  1. Separate the brake shoe return spring, and remove the front brake shoe.



8. REMOVE REAR BRAKE SHOE


    C102603E01
  1. Using SST, remove the cup, shoe hold-down sprig and pin.

    SST
    09718-00010  



    C102606
  1. Disconnect the parking brake cable No.3 and remove the rear brake shoe.



9. REMOVE PARKING BRAKE SHOE STRUT SET


    C102607E01
  1. Using a screwdriver, remove the C-washer, brake shoe lever, rear cushion lever and brake shoe strut set from the brake shoe.

  1. Remove the adjusting bolt and tension spring from the brake shoe strut set.



10. SEPARATE PARKING BRAKE CABLE ASSEMBLY NO.3


    C102159
  1. Remove the 2 bolts and separate the parking brake cable assembly No.3 from the rear brake backing plate.



11. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY


    C102608
  1. Using SST, disconnect the brake tube, use a container to catch brake fluid.

    SST
    09023-00101  

  1. Remove the 2 bolts and wheel cylinder.



12. SEPARATE REAR SPEED SENSOR (w/ ABS)


    C102662E01
  1. Remove the bolt and separate the rear speed sensor.

    NOTICE:
    1. Prevent foreign matter from adhering to the speed sensor.
    2. Be careful not to damage the speed sensor.

  1. Remove the O-ring from the rear speed sensor.



13. REMOVE REAR AXLE SHAFT WITH BACKING PLATE


    C102664J01
  1. Remove the 4 nuts and rear axle shaft with backing plate.

    NOTICE:
    1. Be careful not to damage the rear axle shaft oil seal.
    2. Be careful not to damage the skid control rotor rear.



14. REMOVE BEARING RETAINER O-RING
  1. Remove the bearing retainer O-ring from the rear axle housing assembly.



15. REMOVE REAR AXLE SHAFT OIL SEAL


    C102232E01
  1. Using SST, remove the rear axle shaft oil seal from the rear axle housing assembly.

    SST
    09308-00010