Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR SKID CONTROL ROTOR (w/ ABS)


    C102233E01
  1. Temporarily install the nut to the rear brake backing plate No.1 bolt as shown in the illustration.

  1. Using a hammer, remove the 4 bolts from the rear axle shaft bearing case.

    NOTICE:
    Do not reuse the nuts previously removed from the vehicle.



    C102234
  1. Grind the bearing retainer inner and skid control rotor rear surfaces using a grinder, then chisel them out with a chisel.

    NOTICE:
    Be careful not to damage the rear axle shaft and backing plate.



2. REMOVE REAR AXLE SHAFT SNAP RING


    C102235
  1. Using a snap ring expander, remove the rear axle shaft snap ring.



3. REMOVE REAR AXLE SHAFT


    C102236E01
  1. Install a washer and nut to the rear brake backing plate No.1 bolt as shown in the illustration.

  1. Install the rear brake backing plate No.1 bolt by tightening the nut.



    C102237E01
  1. Position SST on the rear brake backing plate with the 4 nuts.

    SST
    09521-25011  

  1. Using SST and a press, remove the rear axle shaft from the rear axle shaft bearing.

    NOTICE:
    Be careful not to drop the rear axle shaft.



4. REMOVE REAR AXLE BEARING RETAINER INNER
  1. Remove the rear axle bearing retainer inner.



5. REMOVE BRAKE DRUM OIL DEFLECTOR


    C102238E01
  1. Using SST, remove the rear axle hub bolts.

    SST
    09650-17011  

  1. Remove the brake drum oil deflector and brake drum oil deflector gasket.



6. REMOVE REAR AXLE SHAFT OUTER OIL SEAL


    C102239E01
  1. Using SST, remove the rear axle shaft outer oil seal.

    SST
    09308-00010  



7. REMOVE REAR AXLE SHAFT BEARING


    C102240E01
  1. Using SST and a press, remove the rear axle shaft bearing from the rear axle shaft bearing case.

    SST
    09223-56010  
    09950-60010   (09951-00600)



8. REMOVE REAR AXLE BEARING CASE


    C102241
  1. Temporarily install the nut to the rear brake backing plate No.1 bolt as shown in the illustration.

  1. Using a hammer, remove the 4 bolts from the rear axle shaft bearing case.

    NOTICE:
    Do not reuse the nuts previously removed from the vehicle.



9. INSPECT REAR AXLE SHAFT


    G020972
  1. Using a dial indicator, inspect the rear axle shaft runout.

    Maximum:
    0.8 mm (0.0315 in.)

    NOTICE:
    Ensure that the dial indicator is set at right angles to the measurement surface.

    If runout exceeds the maximum, replace the rear axle shaft.

  1. Check the rear axle shaft for damage.