Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL REAR AXLE BEARING CASE
  1. Install the rear axle bearing case to the rear brake backing plate.



    C102242E01
  1. Using a deep socket wrench (10 mm), socket wrench (21 mm) and press, install the 4 rear brake backing plate No.1 bolts.



2. INSTALL REAR AXLE SHAFT BEARING


    C102271E01
  1. Using SST and a press, install a new rear axle shaft bearing.

    SST
    09950-60020   (09951-00910)



3. INSTALL REAR AXLE SHAFT OUTER OIL SEAL


    C103374E01
  1. Using SST and a hammer, install a new rear axle shaft outer oil seal to the rear axle shaft bearing case.

    SST
    09223-22010  
    09612-30012  

  1. Apply MP grease to the oil seal lip.



4. INSTALL BRAKE DRUM OIL DEFLECTOR


    C103891E01
  1. Aligning the notches, install the brake drum oil deflector, brake drum oil deflector gasket and rear axle hub bolts.

  1. Hold the rear axle shaft in a vise between aluminium plates.

    NOTICE:
    Do not overtighten the vise.



    C102273E01
  1. Install a washer and nut to the rear axle hub bolt as shown in the illustration.

  1. Install the rear axle hub bolt by tightening the nut.



5. INSTALL REAR AXLE SHAFT
  1. Install the rear axle shaft sub-assembly to the rear axle shaft bearing.

  1. Install the bearing retainer inner to the rear axle shaft bearing.

    NOTICE:
    Be sure to install the bearing retainer inner in the correct direction.



    C113821E01
  1. Using SST and a press, install the rear axle shaft sub-assembly to the rear axle shaft bearing.

    SST
    09316-60011   (09316-00051)



6. INSTALL REAR AXLE SHAFT SNAP RING


    C114603
  1. Using a snap ring expander, install the new rear axle shaft snap ring.



7. INSTALL SKID CONTROL ROTOR REAR (w/ ABS)


    C102276E01
  1. Install a new rear skid control rotor to the rear axle shaft sub-assembly, as shown in the illustration.

    NOTICE:
    1. Be sure to install the skid control rotor rear in the correct direction.
    2. Be careful not to damage the skid control rotor rear.



    C102277E01
  1. Using SST and a press, install the skid control rotor rear and bearing retainer inner.

    SST
    09316-60011   (09316-00051)

    Standard:
    31 to 33 mm (1.2205 to 1.2992 in.)

    NOTICE:
    Be sure to install the bearing retainer inner in the correct direction.