Home › TRANSMISSION ยท CLUTCH › 5L-E CLUTCH UNIT

5L-E CLUTCH UNIT > INSTALLATION

for Preparation Click here



1. INSTALL INPUT SHAFT BEARING


    C103898E01
  1. Using SST and a hammer, install a new input shaft bearing.

    SST
    09304-12012  

  1. Install the 2 bolts.

    Torque:
    123 N*m{ 1,250 kgf*cm , 90 ft.*lbf }



2. INSTALL CLUTCH DISC ASSEMBLY


    C104158E01
  1. Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.

    SST
    09301-00110  

    NOTICE:
    Take care not to insert the clutch disc assembly in the wrong direction.



3. INSTALL CLUTCH COVER ASSEMBLY


    C114265E02
  1. Align the matchmarks on the clutch cover assembly with the one on the flywheel sub-assembly.

  1. Following the procedures shown in the illustration, tighten the 6 bolts starting from the bolt located near the knock pin on the top.

    SST
    09301-00110  

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    HINT:
    1. Evenly tighten the bolts by following the order shown in the illustration.
    2. Tighten the bolts after checking that the disc is in the center by lightly moving the SST up and down, left and right.



4. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY


    C086210
  1. Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.

    Maximum non-alignment:
    0.9 mm (0.035 in.)



    C114266E01
  1. If alignment is not as specified, adjust the diaphragm spring tip alignment using SST.

    SST
    09333-00013  



5. INSTALL CLUTCH RELEASE FORK BOOT


    C086354
  1. Install the clutch release fork boot.



6. INSTALL RELEASE FORK SUPPORT


    C086353J01
  1. Install the clutch release fork support to the transmission unit.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }



7. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY


    C104160
  1. Apply release hub grease to the release fork, the release bearing assembly, the push rod contact point and the pivot points as shown in the illustration.

    Sealant:
    Part No. 08887-01806, RELEASE HUB GREASE or equivalent



    C103116J02
  1. Apply clutch spline grease to the input shaft spline.

    Sealant:
    Part No. 08887-01706, CLUTCH SPLINE GREASE or equivalent



    C103906E01
  1. Install the release bearing to the clutch release fork with the clip.

  1. Install the clutch release fork assembly to the transmission unit.

    NOTICE:
    After installation, move the fork back and forth to check that the release bearing slides smoothly.



8. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY
(Click here)