Home › TRANSMISSION ยท CLUTCH › 5L-E CLUTCH UNIT

5L-E CLUTCH UNIT > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY
(Click here)


2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY


    C103906E01
  1. Remove the clutch release fork with the clutch release bearing from the transmission unit.

  1. Remove the release bearing and clip from the clutch release fork.



3. REMOVE CLUTCH RELEASE FORK BOOT


    C086354
  1. Remove the clutch release fork boot from the transmission unit.



4. REMOVE RELEASE FORK SUPPORT


    C086353J01
  1. Remove the release fork support from the transmission unit.



5. REMOVE CLUTCH COVER ASSEMBLY


    C114267E01
  1. Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

  1. Loosen each set bolt one turn at a time until spring tension is released.

    NOTICE:
    Do not drop the clutch disc assembly.

  1. Remove the set bolts, and pull off the clutch cover assembly.



6. REMOVE CLUTCH DISC ASSEMBLY

NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.



7. INSPECT INPUT SHAFT BEARING


    Q002481
  1. Turn the bearing by hand while applying force in the direction of the rotation.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.



8. REMOVE INPUT SHAFT BEARING


    C103897E01
  1. Remove the 2 bolts at symmetrically opposite points.

  1. Using SST, remove the input shaft bearing.

    SST
    09303-35011