Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF SHOCK ABSORBER ASSEMBLY REAR


    C112177E01
  1. Fully extend the shock absorber rod.

  1. Using a drill, make a hole in the cylinder somewhere between A and B, as shown in the illustration, to discharge the gas inside.

    CAUTION:
    1. Be careful of flying metal shards when drilling. Always use proper safety equipment.
    2. The gas is colorless, odorless and non-poisonous.