Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > INSTALLATION

for Preparation Click here



1. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY


    C112188E01
  1. Install the 2 rear shock absorber bushings on the rear shock absorber.

    NOTICE:
    Be careful of size differences between the upper and lower rear shock absorber bushings.

    HINT:
    If the rear shock absorber bushing is separated, install it as shown in the illustration.



    C103907E01
  1. Install the cushion washer No.2.

  1. Temporarily tighten the upper side of the rear shock absorber assembly with the bolt.



    C103908E01
  1. Install the cushion washer No.4.

  1. Temporarily tighten the lower side of the rear shock absorber assembly with the bolt.



2. STABILIZE SUSPENSION
  1. After lowering the vehicle, bounce the vehicle up and down to stabilize the rear suspension.



3. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY


    C101411
  1. Fully tighten the bolt on the upper side.

    Torque:
    24 N*m{ 245 kgf*cm , 18 ft.*lbf }



    C101410
  1. Fully tighten the bolt on the lower side.

    Torque:
    43 N*m{ 440 kgf*cm , 32 ft.*lbf }