Home › SUSPENSION & AXLE › AXLE › STEERING KNUCKLE

STEERING KNUCKLE > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. SEPARATE FRONT SPEED SENSOR (w/ ABS)


    C102281E01
  1. Remove the 2 bolts, and separate the speed sensor from the steering knuckle.

    NOTICE:
    1. Be careful not to damage the speed sensor.
    2. Prevent foreign matter from adhering to the speed sensor.



3. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY


    C102283E01
  1. Remove the 2 bolts, and disconnect the brake caliper assembly.

    NOTICE:
    Use a wire or an equivalent to keep the brake caliper from hanging down by the flexible hose.



4. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and castle nut.



    C102285E01
  1. Using SST, separate the tie rod end from the steering knuckle.

    SST
    09628-00011  

    NOTICE:
    1. Do not damage the ball joint dust boot.
    2. Do not damage the brake dust cover.
    3. Make sure that the string of the SST is securely tied to the vehicle.



5. REMOVE FRONT AXLE ASSEMBLY


    C102287
  1. Remove the 4 bolts, 4 nuts and front axle assembly from the front suspension lower arm.

  1. Remove the cotter pin and castle nut.



    C102660E01
  1. Using SST, remove the front axle assembly from the front suspension upper arm.

    SST
    09628-62011  

    NOTICE:
    1. Do not damage the ball joint dust boot.
    2. Apply grease to the threads and tip of the SST center bolt before use.
    3. Make sure that the string of the SST is securely tied to the vehicle.



6. REMOVE FRONT LOWER BALL JOINT ASSEMBLY
  1. Fix the steering knuckle in the vise using aluminium plates.

    NOTICE:
    Do not damage the steering knuckle.

  1. Remove the cotter pin.

  1. Loosen the nut.



    C103882E01
  1. Use SST to separate the front lower ball joint assembly from the steering knuckle.

    SST
    09628-62011  

    NOTICE:
    1. Do not damage the ball joint dust boot.
    2. Apply grease to the threads and tip of the SST center bolt before use.

  1. Remove the nut and front lower ball joint assembly.



7. REMOVE STEERING KNUCKLE


    C103883E01
  1. Remove the 4 bolts.



    C103880E01
  1. Using SST, remove the steering knuckle, brake dust cover from the front axle hub sub-assembly.

    SST
    09950-40011   (09951-04020, 09953-04010, 09952-04010, 09955-04051)

    NOTICE:
    Apply grease to the threads and tip of the SST center bolt (09953-04010) before use.