MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL > INSTALLATION |
| 1. INSTALL MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL |
![]() |
Using SST and a hammer, install a new oil seal to the extension housing.
Coat the lip of the oil seal with MP grease.
| 2. INSTALL PROPELLER SHAFT ASSEMBLY (for Long Wheelbase) |
![]() |
Remove the SST from the extension housing.
Install the propeller shaft assembly in the extension housing.
Align the matchmarks on the propeller shaft flange and differential flange.
![]() |
Install the propeller shaft assembly with the 4 nuts, 4 bolts and 4 washers.
| 3. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for Super Long Wheelbase) |
![]() |
Remove the SST from the extension housing.
Install the propeller with center bearing shaft assembly in the extension housing.
![]() |
Install the center support bearing assembly No.1, and temporarily tighten the 2 bolts.
![]() |
Align the matchmarks on the propeller shaft flange and differential flange.
Install the propeller shaft assy with the 4 nuts, 4 bolts and 4 washers.
![]() |
Check that the center line of the bracket is at right angles to the shaft axial direction.
![]() |
Adjust the center support bearing assembly No.1.
Tighten the 2 bolts.
| 4. ADD MANUAL TRANSMISSION OIL |
![]() |
Park the vehicle in a level place.
Remove the transmission filler plug and gasket.
Check that the oil surface is within 5 mm (0.20 in.) below the lowest point of the transmission filler plug opening.
Check for oil leakage if the oil level is low.
Install the transmission filler plug and a new gasket.