Home › TRANSMISSION ยท G55 MANUAL TRANSMISSION › SHIFT LEVER ASSEMBLY

SHIFT LEVER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL SHIFT LEVER ASSEMBLY


    C102617
  1. Install the shift lever assembly with the 4 bolts.

    Torque:
    14 N*m{ 140 kgf*cm , 10 ft.*lbf }



2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    C114293E01
  1. Install the transmission control cable assembly to the shift lever.

    NOTICE:
    Install the transmission control cable assembly so that the end section of the select cable indicated by the arrow, as shown in the side view, (A in the illustration) faces upward.



    C116457E01
  1. Turn the control cable assembly adjust nut clockwise 180°. While holding the adjust nut, push in the locks.

  1. Install the control cable assembly to the shift lever.

    NOTICE:
    Make sure that the control cable assembly is firmly installed to the shift lever.

    HINT:
    When the cable is installed to the shift lever, the locks are released and the adjust nut rotates 180°. Then, the locks are engaged again.



3. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER


    B102832E01
  1. Engage the 8 claws and install the instrument panel finish panel lower center.



4. INSTALL SHIFTING HOLE COVER ASSEMBLY


    B102831E01
  1. Manual Transmission:
    Engage the 6 claws and install the shifting hole cover assembly.

  1. Automatic Transmission:
    Engage the 8 claws and install the sifting hole cover assembly.



5. INSTALL SHIFT LEVER KNOB


6. INSTALL PARKING BRAKE HOLE COVER


    B102829E01
  1. Engage the 6 claws and install the parking brake hole cover.



7. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1


    B102828E01
  1. Engage the 3 claws.

  1. Install the instrument panel No.1 under cover sub-assembly with the 2 clips.



8. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER


    B102827E01
  1. Engage the 4 clips (B).

  1. Install the instrument panel finish panel lower with the 2 clips (A).



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. PERFORM INITIALIZATION
Some systems need initialization after reconnecting the cable to the negative battery terminal. (Click here)