Home › TRANSMISSION ยท R351 MANUAL TRANSMISSION › SHIFT LEVER ASSEMBLY

SHIFT LEVER ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER


    B102827E01
  1. Using a clip remover, remove the 2 clips (A).

  1. Disengage the 4 clips (B).

  1. Disconnect the connector.



    B102838
  1. Push the positions indicated by the arrows in the illustration to separate the fuel lid lock control cable and bonnet (hood) control cable assembly from the panel.
    Remove the instrument panel finish lower.



3. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1


    B102828
  1. Using a clip remover, remove the 2 clips

  1. Disengage the 3 claws and remove the instrument panel No.1 under cover sub-assembly.



4. REMOVE PARKING BRAKE HOLE COVER


    B102829E01
  1. Disengage the 6 claws and remove the parking brake hole cover.



5. REMOVE SHIFT LEVER KNOB


    B102830E01
  1. Turn the shift lever knob in the direction indicated by the arrow and remove it.



6. REMOVE SHIFTING HOLE COVER ASSEMBLY


    B102831E01
  1. Manual Transmission:
    Disengage the 6 claws and remove the shifting hole cover assembly.

  1. Automatic Transmission:
    Disengage the 8 claws and remove the shifting hole cover assembly.



7. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER


    B102832E01
  1. Disengage the 8 claws and remove the instrument panel finish panel lower center.



8. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    C114290
  1. Separate the shift lever from the control cable assembly.



    C114292E01
  1. Pull out the control cable assembly locks.

  1. Turn the adjust nut clockwise 180°. While holding the adjust nut, remove the control cable assembly.



9. REMOVE SHIFT LEVER ASSEMBLY


    C102617
  1. Remove the 4 bolts and shift lever assembly.