Home › TRANSMISSION ยท G55 MANUAL TRANSMISSION › SHIFT AND SELECT TRANSMISSION CONTROL CABLE

SHIFT AND SELECT TRANSMISSION CONTROL CABLE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    C102206E01
  1. Put matchmarks on the control cable assembly and the outer lever.

  1. Remove the 2 nuts and separate the transmission control cable assembly from the outer lever.



    C102207
  1. Using a screwdriver, disengage the claws of the 2 clips.

  1. Remove the 2 clips and separate the transmission control cable assembly from the transmission control cable bracket No.1



    C102625
  1. Remove the bolt and control cable support.



    C102621
  1. Remove the bolt and separate the clamp.



    C102620
  1. Remove the 2 nuts and control cable bracket No.2.



3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER


    B102827E01
  1. Using a clip remover, remove the 2 clips (A).

  1. Disengage the 4 clips (B).

  1. Disconnect the connector.



    B102838
  1. Push the positions indicated by the arrows in the illustration to separate the fuel lid lock control cable and bonnet (hood) control cable assembly from the panel.
    Remove the instrument panel finish lower.



4. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1


    B102828
  1. Using a clip remover, remove the 2 clips

  1. Disengage the 3 claws and remove the instrument panel No.1 under cover sub-assembly.



5. REMOVE PARKING BRAKE HOLE COVER


    B102829E01
  1. Disengage the 6 claws and remove the parking brake hole cover.



6. REMOVE SHIFT LEVER KNOB


    B102830E01
  1. Turn the shift lever knob in the direction indicated by the arrow and remove it.



7. REMOVE SHIFTING HOLE COVER ASSEMBLY


    B102831E01
  1. Manual Transmission:
    Disengage the 6 claws and remove the shifting hole cover assembly.

  1. Automatic Transmission:
    Disengage the 8 claws and remove the shifting hole cover assembly.



8. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER


    B102832E01
  1. Disengage the 8 claws and remove the instrument panel finish panel lower center.



9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    C114289
  1. Separate the control cable assembly from the shift lever.



    C114291E01
  1. Pull out the control cable assembly locks.

  1. Turn the adjust nut clockwise 180°. While holding the adjust nut, separate the control cable assembly.



    C112966
  1. Wide body LHD steering position type:

    1. Remove the 2 nuts and clamp.



    C102618
  1. Remove the 2 nuts and front floor footrest.



    C102619
  1. Remove the 2 bolts and transmission control cable assembly.