Home › TRANSMISSION ยท CLUTCH › CLUTCH PEDAL

CLUTCH PEDAL > ADJUSTMENT

for Preparation Click here



1. INSPECT AND ADJUST CLUTCH PEDAL HEIGHT


    C114262E01
  1. Turn back the floor carpet.

  1. Check that the pedal height is correct.

    Pedal height from floor:
    LHD
    RHD
    157.3 to 167.3 mm (6.193 to 6.587 in.)
    160.5 to 170.5 mm (6.319 to 6.713 in.)

  1. Loosen the lock nut and turn the stopper bolt until the correct height is obtained.

  1. Tighten the lock nut.

    Torque:
    26 N*m{ 260 kgf*cm , 19 ft.*lbf }



2. INSPECT CLUTCH PEDAL FREE PLAY AND PUSH ROD PLAY


    C102627E01
  1. Check that pedal free play and push rod play are correct.

    1. Depress the pedal until clutch resistance begins to be felt.

      Pedal free play:
      5.0 to 15.0 mm (0.197 to 0.591 in.)

    2. Gently depress the pedal until resistance begins to increase a little.

      Push rod play at pedal top:
      1.0 to 5.0 mm (0.039 to 0.197 in.)

  1. Adjust the pedal free play and push rod play.

    1. Loosen the lock nut and turn the push rod until correct free play and push rod play are obtained.

    2. Tighten the lock nut.

      Torque:
      12 N*m{ 120 kgf*cm , 9 ft.*lbf }

    3. After adjusting the pedal free play, check the pedal height.



3. INSPECT CLUTCH RELEASE POINT


    C102658E01
  1. Check the clutch release point.

    1. Pull the parking brake lever and install wheel stoppers.

    2. Start the engine and run at idle.

    3. Without depressing the clutch pedal, slowly move the shift lever into reverse until the gears contact.

    4. Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.

      Standard distance:
      25 mm (0.98 in.) or more (from pedal stroke end position to release point)

      Pedal stroke:
      150 mm (5.906 in.)

      If the distance is not as specified, perform the following operations.
      1. Check pedal height.
      2. Check push rod play and pedal free play.
      3. Bleed the clutch line.
      4. Check the clutch cover and disc.