CLUTCH PEDAL > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY CABLE |
| 2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER |
![]() |
Using a clip remover, remove the 2 clips (A).
Disengage the 4 clips (B).
Disconnect the connector.
![]() |
Push the positions indicated by the arrows in the illustration to separate the fuel lid lock control cable and bonnet (hood) control cable assembly from the panel.
Remove the instrument panel finish lower.
| 3. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1 |
![]() |
Using a clip remover, remove the 2 clips
Disengage the 3 claws and remove the instrument panel No.1 under cover sub-assembly.
| 4. REMOVE PARKING BRAKE HOLE COVER |
![]() |
Disengage the 6 claws and remove the parking brake hole cover.
| 5. REMOVE SHIFT LEVER KNOB |
![]() |
Turn the shift lever knob in the direction indicated by the arrow and remove it.
| 6. REMOVE SHIFTING HOLE COVER ASSEMBLY |
![]() |
Manual Transmission:
Disengage the 6 claws and remove the shifting hole cover assembly.
Automatic Transmission:
Disengage the 8 claws and remove the shifting hole cover assembly.
| 7. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Disengage the 8 claws and remove the instrument panel finish panel lower center.
| 8. REMOVE WASHER TANK AND PUMP ASSEMBLY (for LHD) |
| 9. REMOVE AIR DUCT NO.1 (for RHD) |
![]() |
Remove the clip.
Release the 2 claws and remove the air duct No.1.
| 10. SEPARATE CLUTCH MASTER CYLINDER ASSEMBLY |
![]() |
Remove the 2 nuts and separate the clutch master cylinder from the clutch pedal support.
| 11. REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY |
![]() |
Push the push rod clevis upward and release it toward the right side of the vehicle.
![]() |
Remove the 2 bolts and clutch pedal support.
| 12. REMOVE CLUTCH PEDAL SPRING (2KD-FTV ENGINE TYPE) |
![]() |
Using a screwdriver, remove the E-ring.
Remove the clutch pedal spring.
| 13. REMOVE TURNOVER SPRING SEAT COMPRESSION SPRING |
![]() |
Mount the clutch pedal in a soft jaw vise.
While the clutch pedal is fully depressed, remove the compression spring.
| 14. REMOVE CLUTCH PEDAL SUB-ASSEMBLY |
![]() |
Put matchmarks on the clutch pedal support.
Remove the pedal shaft, nut, washer, and clutch pedal from the clutch pedal support.
| 15. REMOVE CLUTCH PEDAL SHAFT COLLAR |
![]() |
Remove the 2 pedal bushings and pedal shaft collar from the clutch pedal.
| 16. REMOVE CLUTCH PEDAL NO.1 CUSHION |
![]() |
Remove the clutch pedal No.1 cushion.
| 17. REMOVE CLUTCH PEDAL PAD |
Remove the clutch pedal pad from the clutch pedal.
| 18. REMOVE CLUTCH PEDAL SPRING HOLDER |
![]() |
Remove the clutch pedal spring holder from the clutch pedal support.