Home › TRANSMISSION ยท CLUTCH › CLUTCH MASTER CYLINDER

CLUTCH MASTER CYLINDER > REMOVAL

for Preparation Click here



1. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it spills on any painted surface.



2. REMOVE WASHER TANK AND PUMP ASSEMBLY (for LHD)


3. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY


    C102639
  1. Slide the clip and separate the clutch reservoir tube.

    HINT:
    Use a container to catch the fluid.

  1. Using SST, disconnect the clutch tube from the clutch master cylinder.

    SST
    09023-00101  

    HINT:
    Use a container to catch the fluid.



    C102636
  1. Push the push rod clevis upward and release it toward the right side of the vehicle.



    C102638
  1. Remove the 2 nuts and clutch master cylinder.



4. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS


    C102640E01
  1. Loosen the lock nut and remove the push rod clevis.

  1. Remove the lock nut.

    HINT:
    Measure dimension A shown in the illustration so that the measurement can be used as a reference when installing the push rod clevis.