Home › TRANSMISSION ยท CLUTCH › CLUTCH RELEASE CYLINDER

CLUTCH RELEASE CYLINDER > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY


    C102642E01
  1. Install the clutch release cylinder with the 2 bolts.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }



2. INSTALL CLUTCH HOSE NO.1


    C102641E02
  1. Using SST, install the clutch hose No.1 to the clutch release cylinder (Procedure A).

    SST
    09023-12701  

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }

  1. Connect the clutch hose No.1 to the bracket with a new clip (Procedure B).

  1. Using SST, connect the clutch tube to the clutch hose No.1 (Procedure C).

    SST
    09023-00101  

    Torque:
    20 N*m{ 200 kgf*cm , 14 ft.*lbf }



3. ADD BRAKE FLUID


C106088

Fluid:
SAE J1704 or FMVSS No. 116 DOT3 or equivalent



4. BLEED CLUTCH LINE
  1. Fill the brake reservoir tank with brake fluid and bleed the clutch system.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }



5. CHECK FOR BRAKE FLUID LEAKAGE

HINT:
Check for leakage in the clutch system.



6. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
  1. Check the fluid level and add fluid if necessary.

    Fluid:
    SAE J1704 or FMVSS No.116 DOT3 or equivalent