Home › TRANSMISSION ยท CLUTCH › CLUTCH RELEASE CYLINDER

CLUTCH RELEASE CYLINDER > REASSEMBLY

for Preparation Click here



1. INSTALL CLUTCH RELEASE CYLINDER KIT


    CL00672
  1. Coat a new piston with lithium soap base glycol grease, as shown in the illustration.



    C114264E01
  1. Install the piston and a new spring to the cylinder body.

    NOTICE:
    Do not damage the inside of the cylinder body.

    HINT:
    Install the smaller end of the spring to the piston.

  1. Install a new boot to the push rod.

  1. Install the push rod to the cylinder body.



2. INSTALL RELEASE CYLINDER BLEEDER PLUG
  1. Install the bleeder plug to the cylinder body.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Install the bleeder plug cap to the bleeder plug.