Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Install the park/neutral position switch to the automatic transmission.



    C080256
  1. Temporarily install the bolt.



    C080255
  1. Install a new lock washer and the nut.

    Torque:
    6.9 N*m{ 70 kgf*cm , 61 in.*lbf }



    C101788E01
  1. Turn the control shaft lever clockwise until it stops, and turn it counterclockwise 2 notches to set it to the N position.



    D025795E06
  1. Align the neutral basic line with the switch groove, and tighten the adjusting bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



    C080254
  1. Using a screwdriver, bend the tabs of the lock washer.



    C101787E01
  1. Connect the park/neutral position switch connector.



2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    C101771E01
  1. Connect the control cable with a new clip to the bracket.

  1. Temporarily install the control cable to the control shaft lever with the nut.

    Torque:
    15 N*m{ 150 kgf*cm , 10 ft.*lbf }



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Apply the parking break and turn ignition switch on.

  1. Depress the break pedal and check that the engine starts only when the shift lever is set in N or P position and it does not start in other positions.

  1. Check that the back up light is lit and the reverse warning buzzer sounds only when the shift lever is set in R position and these do not function.

  1. If a failure is found, check the park/neutral position switch for continuity.



5. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    D025795E05
  1. Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.

  1. Align the groove and the neutral basic line.

  1. Hold the switch in position and tighten the bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. After adjustment, perform the switch operation check.



6. INSPECT SHIFT LEVER POSITION
  1. When shifting from P position only with ignition switch ON and depress the break pedal.

  1. Make sure that the shifting lever moves smoothly and can be moderately operated.

  1. When starting engine, make sure that the vehicle moves forward when shifting from N to D position and moves reward when shifting R position.



7. ADJUST SHIFT LEVER POSITION


    D025795E05
  1. Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.

  1. Align the groove and the neutral basic line.

  1. Hold the switch in position and tighten the bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. After adjustment, perform the switch operation check.



8. PERFORM INITIALIZATION
(Click here)