PARK / NEUTRAL POSITION SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY |
Set the shift lever to the neutral position.
![]() |
Remove the nut from the control shaft lever.
Remove the clip and disconnect the control cable from the control cable bracket.
| 3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Disconnect the park/neutral position switch connector.
![]() |
Using a screwdriver, pry out the lock washer.
Remove the lock nut and lock washer.
![]() |
Remove the bolt and park/neutral position switch.