TORQUE CONVERTER CLUTCH AND DRIVE PLATE > INSPECTION |
| 1. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
![]() |
Inspect the one-way clutch.
Install the SST so that it fits in the notch of the converter hub and the outer race of the one-way clutch.
Install the SST (Stopper) from the sleeve of torque converter assembly and engage serration of stater slight washer.
Stand up the torque converter and turn the SST (tool ).
![]() |
Determine the condition of the torque converter clutch assembly.
If the inspection result of the torque converter clutch assembly meets the following item, replace the torque converter clutch.
Replace the ATF in the torque converter clutch.
If the ATF is discolored and/or has a foul odor, completely stir the ATF in the torque converter clutch and drain it with the installation face up.
![]() |
Clean and check the oil cooler and oil pipe line.
If the torque converter clutch is inspected or exchange the ATF, is exchanged, clean the oil cooler and oil pipe line.
If the ATF is cloudy, inspect the oil cooler.