Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › TRANSMISSION WIRE

TRANSMISSION WIRE > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION WIRE


    C058095E01
  1. Coat a new O-ring with ATF and install it to the transmission wire.



    G022489
  1. Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. CONNECT TRANSMISSION WIRE


    C058460
  1. Connect the ATF temperature sensor connector and shift solenoid valve connectors.



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


    G021841E03
  1. Install 3 new gaskets.

  1. Install the oil strainer with the 4 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    Bolt length:

    Bolt A:
    14 mm (0.55 in.)
    Bolt B:
    20 mm (0.79 in.)
    Bolt C:
    23 mm (0.91 in.)



4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    D029014E02
  1. Install the 3 magnets in the indications of the oil pan sub-assembly.

  1. Remove any packing material and be careful not to drop oil on the contacting surfaces of the transmission case and oil pan sub-assembly .

    NOTICE:
    Apply seal packing to the contact surface and install the oil pan with in 10 minutes of application.



    D028715
  1. Apply FIPG to the oil pan, as shown in the illustration.

    FIPG:
    Part No.08826-00090, TREE BOND 1281 or equivalent



    G022488
  1. Uniformly tighten the 19 bolts in several times and install the transmission oil pan.

    Torque:
    7.4 N*m{ 75 kgf*cm , 65 in.*lbf }



5. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


    C101768E01
  1. Coat a new O-ring with ATF, and install it to the oil filler tube.

  1. Install the oil filler tube to the automatic transmission with the 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. ADD AUTOMATIC TRANSMISSION FLUID


8. INSPECT AUTOMATIC TRANSMISSION FLUID

HINT:
Drive the vehicle so that the engine and transmission are at normal operating temperature.

Fluid temperature:
70 to 80 °C (158 to 176 °F)



    D025120E01
  1. Park the vehicle on a level surface and set the parking brake.

  1. With the engine idling and the brake pedal depressed, move shift the lever into all positions from P to L and return to the P position.

  1. Take out the dipstick and wipe it clean.

  1. Put it back all the way.

  1. Take it out again and check that the fluid level is within the HOT range.
    If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add the proper amount of new fluid and recheck the fluid level.



9. PERFORM INITIALIZATION
(Click here)