TRANSMISSION WIRE > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY |
![]() |
Remove the transmission oil level gauge.
| 3. DRAIN AUTOMATIC TRANSMISSION FLUID |
![]() |
Remove the drain plug, gasket and drain the ATF.
Install a new gasket and the drain plug.
| 4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and transmission oil filler tube.
Remove the O-ring from the oil filler tube.
| 5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
![]() |
Uniformly loosen the 19 bolts and remove the transmission oil pan sub-assembly.
![]() |
Install the blade of SST between the transmission case and oil pan, cut off applied sealer and remove the oil pan.
![]() |
Remove the 3 magnets from the oil pan.
Examine particles in the pan.
![]() |
Collect any steel chips with the removed magnets. Carefully look at the foreign objects and particles in the pan and on the magnets to guess at the type of wear which might be found in the transmission. Steel (magnetic)... bearing, gear and clutch plate wear. Brass (non-magnetic)... bushing wear
| 6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Remove the 4 bolts and oil strainer.
Remove the 3 gaskets from the oil strainer.
| 7. SEPARATE TRANSMISSION WIRE |
![]() |
Disconnect the ATF temperature sensor connector and shift solenoid valve connectors.
| 8. REMOVE TRANSMISSION WIRE |
![]() |
Remove the bolt and pull out the transmission wire.
![]() |
Remove the O-ring from the transmission wire.