Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY


    C101767
  1. Remove the ATF level gauge sub-assembly.



3. DRAIN AUTOMATIC TRANSMISSION FLUID


    C101769E01
  1. Remove the drain plug, the gasket , and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }



4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


    C101768E01
  1. Remove the 2 bolts and transmission oil filler tube sub-assembly.

  1. Remove the O-ring from the oil filler tube sub-assembly.



5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    G022488
  1. Remove the 19 bolts and oil pan sub-assembly.



    Q007487E01
  1. Install the blade of SST between the transmission case and oil pan, cut off applied sealer and remove the oil pan.

    SST
    09032-00100  

    NOTICE:
    When removing the oil pan, be careful not to damage the oil pan flange.



    D029014E02
  1. Remove the 3 magnets from the oil pan.



    AT00103
  1. Examine particles in pan.

    1. Remove the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission. Steel (magnetic) ... bearing, gear and clutch plate wear Brass (non-magnetic) ... bushing wear



6. TEMPORARILY TIGHTEN VALVE BODY OIL STRAINER ASSEMBLY


    G021841E01
  1. Remove the 4 bolts and oil strainer.

  1. Remove the 3 gaskets from the oil strainer.



7. SEPARATE TRANSMISSION WIRE


    C058460
  1. Separate the ATF temperature sensor connector and shift solenoid valve connectors.



8. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    D029011
  1. Remove the 20 bolts and valve body assembly.



9. REMOVE SHIFT SOLENOID VALVE


    D028710E01
  1. Remove the bolt and shift solenoid valve S1 and S2.

  1. Remove the bolt and shift solenoid valve SL.

  1. Remove the bolt, solenoid lock plate and shift solenoid valve SLT.

  1. Remove the O-rings from the shift solenoid valves (S1, S2, SL).