Home › TRANSMISSION · A340E AUTOMATIC TRANSMISSION › SHIFT LOCK SYSTEM

SHIFT LOCK SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY


    C113859E01
  1. Disconnect the transmission control switch connector of shift lock control unit assembly.

  1. Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.
    Resistance: 
    Shift position
    Tester connection
    Specified condition
    D
    9 - 2 (NSSD - ATD)
    Below 1 Ω
    3
    10 kΩ or higher
    D
    9 - 3 (NSSD - AT3)
    Below 1 Ω
    3
    10 kΩ or higher