SHIFT LEVER ASSEMBLY > INSTALLATION |
| 1. INSTALL SHIFT LOCK CONTROL UNIT ASSEMBLY |
![]() |
Install the shift lock control unit assembly with the 4 bolts.
Install the shift lock computer connector and the indicator light wire connector.
| 2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Connect the cable end to the shift lock control unit.
![]() |
Turn the nut on the transmission control cable counterclockwise unit it stops it in place.
Connect the transmission control cable to the shift lock control unit housing.
| 3. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Engage the 8 claws and install the instrument panel finish panel lower center.
| 4. INSTALL PARKING BRAKE HOLE COVER |
![]() |
Engage the 6 claws and install the parking brake hole cover.
| 5. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER |
![]() |
Engage the 4 clips (B).
Install the instrument panel finish panel lower with the 2 clips (A).
| 6. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1 |
![]() |
Engage the 3 claws.
Install the instrument panel No.1 under cover sub-assembly with the 2 clips.
| 7. INSTALL SHIFT LOCK RELEASE BUTTON |
![]() |
Install the shift lock release button to the shift position indicator housing.
| 8. INSTALL SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY |
| 9. INSTALL SHIFT LEVER KNOB |
| 10. CONNECT BATTERY NEGATIVE TERMINAL |
| 11. INSPECT SHIFT LEVER POSITION |
When shifting from P position only with ignition switch ON and depress the break pedal.
Make sure that the shifting lever moves smoothly and can be moderately operated.
When starting engine, make sure that the vehicle moves forward when shifting from N to D position and moves reward when shifting R position.
| 12. ADJUST SHIFT LEVER POSITION |
![]() |
Remove a clip, nut, and disconnect between the control shaft lever to transmission control cable assembly from the control shaft lever and transmission control cable bracket No.1.
![]() |
Turn the control shaft lever until stop to a clockwise direction, return the control shaft lever 2 notches to N position.
![]() |
Set the shift lever to N position while holding the shift lever lightly toward the R position side and install it.
Inspect the operation condition and work.
| 13. PERFORM INITIALIZATION |