SHIFT LEVER ASSEMBLY > REMOVAL |
| 1. DISCONNECT BATTERY NEGATIVE CABLE |
| 2. REMOVE SHIFT LEVER KNOB |
![]() |
Turn the shift lever knob in the direction indicated by the arrow and remove it.
| 3. REMOVE SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY |
![]() |
Manual Transmission:
Disengage the 6 claws and remove the shifting hole cover assembly.
Automatic Transmission:
Disengage the 8 claws and remove the shifting hole cover assembly.
| 4. REMOVE SHIFT LOCK RELEASE BUTTON |
![]() |
Remove the shift lock release button from the floor shift position indicator housing.
| 5. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1 |
![]() |
Using a clip remover, remove the 2 clips
Disengage the 3 claws and remove the instrument panel No.1 under cover sub-assembly.
| 6. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER |
![]() |
Using a clip remover, remove the 2 clips (A).
Disengage the 4 clips (B).
Disconnect the connector.
![]() |
Push the positions indicated by the arrows in the illustration to separate the fuel lid lock control cable and bonnet (hood) control cable assembly from the panel.
Remove the instrument panel finish lower.
| 7. REMOVE PARKING BRAKE HOLE COVER |
![]() |
Disengage the 6 claws and remove the parking brake hole cover.
| 8. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Disengage the 8 claws and remove the instrument panel finish panel lower center.
| 9. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Turn the nut on the transmission control cable counterclockwise.
Disconnect the transmission control cable from the shift lock control unit housing.
Disconnect the end of the transmission control cable from the shift lock control unit.
| 10. REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY |
![]() |
Disconnect the shift lock computer connector and indicator light wire connector.
Remove the 4 bolts and shift control unit assembly.