Home › SUSPENSION & AXLE › SUSPENSION › REAR LEAF SPRING

REAR LEAF SPRING > REMOVAL

for Preparation Click here



1. REMOVE SPARE TIRE


2. REMOVE REAR WHEEL


3. SEPARATE CABLE SUPPORT BRACKET NO.3


    C102264
  1. Remove the 2 bolts and separate the cable support bracket No.3.



4. SEPARATE REAR SHOCK ABSORBER ASSEMBLY


    C112184E01
  1. Support the rear axle housing assembly with a jack using a wooden block to avoid damage.



    C103912E01
  1. Remove the bolt and separate the rear shock absorber assembly.

  1. Remove the cushion washer No.4.



5. REMOVE SPRING U-BOLT SEAT SUB-ASSEMBLY


    C101414
  1. Remove the 4 nuts, 4 washers, 2 rear spring U-bolts and spring U-bolt seat sub-assembly.



6. LOOSEN REAR LEAF SPRING ASSEMBLY


    C101416E01
  1. Loosen the nut.

    NOTICE:
    Do not remove the loosened bolt and nut.



7. REMOVE REAR LEAF SPRING ASSEMBLY


  1. Remove the bolt and leaf spring dynamic damper. (w/ dynamic damper type)


    C112186E01

  1. Remove the nut, 2 bolts, shackle plate, and spring shackle.

    NOTICE:
    Do not forcibly remove the rear leaf spring assembly to avoid damage by the serrated areas at both ends of the collar of the shackle upper bushing and the rear spring leaf bushing.



    C101416E01
  1. Remove the bolt, nut and rear leaf spring assembly.

    NOTICE:
    Be sure to remove the right and left rear leaf spring assemblies separately to enable the rear axle housing to be supported. Do not remove at the same time.



8. REMOVE REAR SPRING SHACKLE UPPER BUSHING


    C101417E01
  1. Using a brass bar and a hammer, remove the collar.

  1. Remove the 2 rear spring shackle upper bushings.