Home › ENGINE ยท 5L-E › ENGINE CONTROL SYSTEM › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL ECM


    A102890E01
  1. Install the ECM cover with the 4 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the 4 ECM connectors.



    A102889E01
  1. Temporary install the ECM cover w/ ECM to the clamp.

  1. Install the ECM cover w/ ECM with the 2 clips.

    NOTICE:
    Do not use the ECM that has been dropped or given strong impact.

  1. Install the floor carpet.



2. INSTALL FRONT SEAT ASSEMBLY (for Hi-back Seat Type)

HINT:
Use the same procedures described for the LH side. (Click here)



3. INSTALL FRONT SEAT ASSEMBLY (for Low-back Seat Type)

HINT:
Use the same procedures described for the LH side. (Click here)



4. INSTALL FRONT DOOR SCUFF PLATE RH


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. INSTALL BATTERY SERVICE HOLE COVER


7. PERFORM INITIALIZATION
(Click here)