ELECTRIC EGR CONTROL VALVE > REMOVAL |
| 1. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1) |
| 2. SEPARATE VANE PUMP OIL RESERVOIR ASSEMBLY |
![]() |
Remove the 2 bolts. Separate the vane pump oil reservoir assembly.
| 3. DISCONNECT OIL RETURN HOSE (w/ Intercooler) |
![]() |
Loosen the clip.
Disconnect the oil return hose from the intake manifold.
| 4. REMOVE EGR PIPE SUB-ASSEMBLY NO.1 |
![]() |
Disconnect the fuel pressure sensor connector.
![]() |
Remove the 2 bolts, 2 nuts, and the EGR pipe sub-assembly.
Remove the 2 gaskets.
| 5. REMOVE AIR HOSE NO.4 |
![]() |
Loosen the 2 clamps.
Remove the air hose No.4.
| 6. REMOVE DIESEL THROTTLE BODY ASSEMBLY |
![]() |
Disconnect the 2 throttle body connectors.
![]() |
Remove the 2 bolts, 2 nuts, and the diesel throttle body assembly.
Remove the gasket from intake air connector.
| 7. REMOVE ENGINE SERVICE HOLE COVER NO.2 |
![]() |
Roll up the carpet.
Remove the 3 bolts and the engine service hole cover No.2.
| 8. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY |
Remove the vacuum regulating valve.
![]() |
Remove the 2 vacuum hoses and the vacuum regulating valve connector.
Remove the 2 bolts and the vacuum regulating valve.
Remove the EGR valve assembly with the sensor.
![]() |
Remove the bolt, and separate the manifold stay.
Disconnect the vacuum hose from the intake air connector.
![]() |
Disconnect the intake air temperature sensor connector.
Disconnect the EGR valve position sensor connector.
![]() |
Remove the bolt, 2 nuts and the intake air connector assembly.
Remove the 2 gaskets and EGR valve assembly from the intake air connector.