Home › ENGINE ยท 2KD-FTV › INTAKE › INTERCOOLER

INTERCOOLER > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)


2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap.



  1. Loosen the radiator drain cock plug and a cylinder block drain cock plug. Then drain the coolant.


    A103477E01



3. REMOVE RADIATOR GRILLE


    B101611E01
  1. Remove the 2 clips and 2 screws.

  1. Release the 6 claws and 4 clips and remove the radiator grille.



4. REMOVE AIR INLET DUCT


    A106855E01
  1. Remove the 3 clips and the air inlet duct No.2.

  1. Remove the 2 bolts, 2 clips and the air inlet duct No.1.



5. DRAIN WINDSHIELD WASHER FLUID


6. REMOVE WINDSHIELD WASHER JAR ASSEMBLY (w/o Rear Wiper)


    A106861
  1. Remove the 2 bolts.

  1. Separate the hose and connector, and remove the windshield washer jar assembly.



7. REPAIR WINDSHIELD WASHER JAR ASSEMBLY (w/ Rear Wiper)


    A106861
  1. Remove the 2 bolts.

  1. Separate the 2 hoses and 2 connectors, and remove the windshield washer jar assembly.



8. REMOVE RADIATOR RESERVE TANK ASSEMBLY


    A106860
  1. Remove the bolt, and separate the radiator reserve tank assembly from the body panel.

  1. Remove the clip, and disconnect the water by-pass hose No.1.

  1. Remove the clip, and disconnect the water by-pass hose No.2.

  1. Remove the radiator reserve tank assembly.



9. REMOVE HOOD LOCK ASSEMBLY


    A114753
  1. Remove the 3 bolts, hood lock control cable and the hood lock assembly.



10. REMOVE RADIATOR UPPER SUPPORT


    A106856
  1. Remove the 6 bolts, 2 screws and the radiator upper support.



11. REMOVE INTERCOOLER ASSEMBLY


    A106862E01
  1. Loosen the clamp, and disconnect the air hose No.2.

  1. Loosen the clamp, and disconnect the air hose No.3.

  1. Remove the 3 bolts and the intercooler assembly.