Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE CABLE


2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    C102933E05
  1. Remove the nut and disconnect the control cable assembly to the control shaft lever.

  1. Remove the clip and disconnect the control cable assembly.



3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    C101834E01
  1. Remove the 2 bolts and heat insulator assembly from the park/neutral position switch assembly.



    C101840E01
  1. Disconnect the connector from the park/neutral position switch assembly.



    C101836E01
  1. Using a screwdriver, pry out the tabs of nut stopper and remove the lock nut and nut stopper.



    C101837
  1. Remove the bolt and park/neutral position start switch assembly.