Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › TRANSMISSION WIRE

TRANSMISSION WIRE > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE CABLE


2. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY


    C102919
  1. Remove the transmission oil level gauge from the transmission oil filler tube.



3. DRAIN AUTOMATIC TRANSMISSION FLUID


    C101769
  1. Remove the drain plug and gasket and drain the automatic transmission fluid.

  1. Install the drain plug with a new gasket.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }



4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


    C102934E02
  1. Remove the oil filler tube with 2 bolts.

  1. Remove the O-ring from the oil filler tube.



5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    G022488
  1. Uniformly loosen the 19 bolts and remove the transmission oil pan sub-assembly.



    G021840E01
  1. Using oil pan seal cutter, remove the transmission oil pan.

    SST
    09032-00100  

    NOTICE:
    1. Be careful not to damage the oil pan and flange.
    2. Do not incline the oil pan because of any fluid will remain in the oil pan.



    D029014E04
  1. Remove the 3 magnets from the transmission oil pan.



6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    G021841E04
  1. Remove the oil strainer assembly and 3 gaskets with 4 bolts.



7. SEPARATE TRANSMISSION WIRE


    C058460
  1. Disconnect the temperature sensor and 4 transmission solenoid connectors from the transmission valve body.



8. REMOVE TRANSMISSION WIRE


    G022489
  1. Disconnect the transmission wire connector.

  1. Remove the bolt and pull out the transmission wire.



    C058095E01
  1. Remove the O-ring from the transmission wire.