TRANSMISSION CONTROL CABLE > INSTALLATION |
| 1. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Rolled up the floor carpet of the front seat LH and connect the transmission control cable assembly with the 2 bolts.
![]() |
Connect the cable end to the shift lock control unit.
![]() |
Install the outer cable of transmission control cable to the shift lock control unit.
| 2. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Engage the 8 claws and install the instrument panel finish panel lower center.
| 3. INSTALL PARKING BRAKE HOLE COVER |
![]() |
Engage the 6 claws and install the parking brake hole cover.
| 4. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER |
![]() |
Engage the 4 clips (B).
Install the instrument panel finish panel lower with the 2 clips (A).
| 5. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1 |
![]() |
Engage the 3 claws.
Install the instrument panel No.1 under cover sub-assembly with the 2 clips.
| 6. INSTALL SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY |
![]() |
Manual Transmission:
Engage the 6 claws and install the shifting hole cover assembly.
Automatic Transmission:
Engage the 8 claws and install the sifting hole cover assembly.
| 7. INSTALL SHIFT LEVER KNOB |
| 8. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Install the transmission control cable bracket No.2 to the under body with the 2 nuts.
Install the transmission control cable assembly to the transmission control cable bracket No.2.
![]() |
Install the transmission control cable assembly with the 2 bolts.
![]() |
Install the transmission control cable assembly to the control shaft lever and transmission control cable bracket No.1 with a clip and the nut.
| 9. ADJUST SHIFT LEVER POSITION |
![]() |
Remove a clip, nut, and disconnect between the control shaft lever to transmission control cable assembly from the control shaft lever and transmission control cable bracket No.1.
![]() |
Turn the control shaft lever until stop to a clockwise direction, return the control shaft lever 2 notches to N position.
![]() |
Set the shift lever to N position while holding the shift lever lightly toward the R position side and install it.
Inspect the operation condition and work.
| 10. INSPECT SHIFT LEVER POSITION |
When shifting from P position only with ignition switch ON and depress the break pedal.
Make sure that the shifting lever moves smoothly and can be moderately operated.
When starting engine, make sure that the vehicle moves forward when shifting from N to D position and moves reward when shifting R position.
| 11. INSTALL ENGINE SIDE UNDER COVER LH |
| 12. INSTALL ENGINE SIDE UNDER COVER RH |
| 13. INSTALL ENGINE UNDER COVER NO.2 |
| 14. INSTALL ENGINE UNDER COVER NO.1 |