Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE CABLE


2. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY


    C102919
  1. Remove the transmission oil level gauge sub assembly from the transmission oil filler tube.



3. DRAIN AUTOMATIC TRANSMISSION FLUID


    C101769E04
  1. Drain the automatic transmission fluid and remove the drain plug and gasket.

  1. Install the drain plug with a new gasket.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }



4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


    C102934E01
  1. Remove the oil filler tube with 2 bolts.

  1. Remove the O-ring from the oil filler tube.



5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    G022488
  1. Uniformly loosen the 19 bolts and remove the transmission oil pan sub-assembly



    Q007487E01
  1. Install the blade of SST between the transmission case and the oil pan, cut off the applied sealer.

    SST
    09032-00100  

    NOTICE:
    1. Be careful not to damage the oil pan and flange.
    2. Do not incline the oil pan because of any fluid will remain in the oil pan.



    D029014E06
  1. Remove the 3 magnet from the transmission oil pan.



6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    G021841E06
  1. Remove the 4 bolts, oil strainer assembly and 3 gaskets.



7. SEPARATE TRANSMISSION WIRE


    C058460
  1. Disconnect the ATF temperature sensor and 4 transmission solenoid connectors from the transmission valve body.



8. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    D029011
  1. Remove the 20 bolts.



  1. Remove the bolt and transmission solenoid assembly (SL1) and transmission solenoid assembly (SL2).


    C103256E01

  1. Remove the bolt and solenoid lock plate and shift control solenoid (SLU)t.

  1. Remove the bolt and solenoid lock plate and line pressure control solenoid assembly (SLT).

  1. Remove the 2 O-rings from the 2 transmission solenoid assemblies (SL1, SL2).