Home › ENGINE ยท 2TR-FE › ENGINE MECHANICAL › ENGINE FRONT OIL SEAL

ENGINE FRONT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    A102143E01
  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-50010  

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap the oil seal at an angle.

  1. Apply MP grease to a new oil seal lip.



2. INSTALL CRANKSHAFT PULLEY


    G037557E01
  1. Align the pulley set key with the key groove of the pulley, and slide on the pulley.

  1. Using SST, install a new crankshaft pulley bolt.

    SST
    09213-54015   (91651-60855)
    09330-00021  

    Torque:
    260 N*m{ 2,651 kgf*cm , 192 ft.*lbf }

    NOTICE:
    Do not reuse the pulley bolt.



3. INSTALL FAN AND GENERATOR V BELT


G035171E02
  1. Install the drive belt to the pulleys except the drive belt tensioner pulley.

  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

    NOTICE:
    1. The backside of the drive belt should face the tensioner pulley.
    2. Check that the drive belt is properly set to each pulley.



    G036496E02
  1. After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.



4. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Install the engine service hole sub cover with the 5 bolts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



5. INSTALL FRONT DOOR SCUFF PLATE RH


6. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



7. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



8. INSPECT ENGINE OIL LEAKS


9. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

Torque:
13 N*m{ 133 kgf*cm , 10 ft.*lbf }