Home › ENGINE ยท 2TR-FE › ENGINE MECHANICAL › ENGINE FRONT OIL SEAL

ENGINE FRONT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



2. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



3. REMOVE FRONT DOOR SCUFF PLATE RH


4. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the 5 bolts and engine service hole sub cover.



5. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)


6. REMOVE FAN AND GENERATOR V BELT


    A102135E01
  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.

    NOTICE:
    When removing the drive belt, do not use the idle pulley's bolt.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.



7. REMOVE CRANKSHAFT PULLEY


    A102141E01
  1. Using SST, loosen the pulley bolt.

    SST
    09213-54015   (91651-60855)
    09330-00021  

    HINT:
    Tighten the pulley bolt to 2 or 3 threads of the crankshaft.



    A102139E01
  1. Using SST, remove the pulley bolt and pulley.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05010, 09954-05021)

    HINT:
    Apply grease to the thread and tip of the SST (center bolt) prior to use.



8. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    A102144E01
  1. Using a screwdriver with its tip taped, pry out the oil seal.

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.