Home › ENGINE ยท 2TR-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL FAN AND GENERATOR V BELT


G035171E02
  1. Install the drive belt to the pulleys except the drive belt tensioner pulley.

  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

    NOTICE:
    1. The backside of the drive belt should face the tensioner pulley.
    2. Check that the drive belt is properly set to each pulley.



    G036496E02
  1. After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.



2. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Install the engine service hole cover with the 5 bolts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



3. INSTALL FRONT DOOR SCUFF PLATE RH


4. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



5. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side.