Home › ENGINE ยท 2KD-FTV › ENGINE MECHANICAL › TIMING BELT

TIMING BELT > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)


2. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



3. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



4. REMOVE FRONT DOOR SCUFF PLATE RH


5. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the engine service hole sub cover assembly.



6. REMOVE FAN AND GENERATOR V BELT


    A102808E03
  1. Remove the drive belt by rotating the tensioner pulley in clockwise direction to loosen its tension with the pulley set bolt of the tensioner.



7. SET NO.1 CYLINDER TO TDC/ COMPRESSION


    A072847E01
  1. Align the matchmarks of the crankshaft pulley and timing gear case cover by rotating the crankshaft in clockwise direction.

    HINT:
    Make sure that both camnoses on the intake side and exhaust side of the cylinder No.1 face upward.



8. REMOVE TIMING BELT NO.1 COVER
  1. Remove the wire harness clamp.



    A102815
  1. Remove the 6 bolts and timing belt cover No.1.



9. REMOVE TIMING BELT


    A070549E01
  1. Turn the crankshaft in the clockwise direction and align the timing marks as shown in the illustration.



    A070550
  1. Uniformly loosen the 2 bolts, and remove the chain tensioner assembly No.1.

  1. Remove the timing belt.