Home › ENGINE ยท 2KD-FTV › ENGINE MECHANICAL › ENGINE FRONT OIL SEAL

ENGINE FRONT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    A072416E02
  1. Apply a bit of MP grease to a new oil seal's lip.

    NOTICE:
    Keep the lip clean. Do not bring dirt and dust on that area.

  1. Using SST and a hammer, fit the oil seal.

    SST
    09223-46011  

    Acceptable depth from the top flat face of the timing gear case cover:
    0 to 0.5 mm (0 to 0.020 in.)

    NOTICE:
    Be sure to make the oil seal horizontal when embedded.



2. INSTALL CRANKSHAFT PULLEY


    A072417E01
  1. Tighten the bolt holding the crankshaft pulley with SST.

    SST
    09213-58013  
    09330-00021  

    Torque:
    365 N*m{ 3,722 kgf*cm , 270 ft.*lbf }



3. INSTALL FAN AND GENERATOR V BELT


    A102808E03
  1. Install the drive belt by rotating the tensioner pulley in clockwise direction with the pulley set bolt of the tensioner.

    NOTICE:
    Make sure that the V belt is set properly at each pulley.



    A080039E01
  1. Make sure that the indicator mark of the tensioner is within range A.



4. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Install the engine service hole sub cover with the 5 bolts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



5. INSTALL FRONT DOOR SCUFF PLATE RH


6. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)



7. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)



8. CHECK FOR ENGINE OIL LEAKS


9. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

Torque:
13 N*m{ 133 kgf*cm , 10 ft.*lbf }