Home › ENGINE ยท 2KD-FTV › ENGINE MECHANICAL › ENGINE FRONT OIL SEAL

ENGINE FRONT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)


2. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



3. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



4. REMOVE FRONT DOOR SCUFF PLATE RH


5. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the engine service hole sub cover assembly.



6. REMOVE FAN AND GENERATOR V BELT


    A102808E03
  1. Remove the drive belt by rotating the tensioner pulley in clockwise direction to loosen its tension with the pulley set bolt of the tensioner.



7. REMOVE CRANKSHAFT PULLEY


    A072413E01
  1. Remove the bolt holding the crankshaft with SST.

    SST
    09213-58013  
    09330-00021  

  1. Insert the service bolt.



    A072414E01
  1. Remove the crankshaft pulley with SST.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply grease to the thread and tip of the SST (Center bolt) before use.



8. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    A072415E01
  1. Remove the oil seal with SST.

    SST
    09308-10010  
    09950-50013   (09957-04010)
    09950-60010   (09951-00350)

    NOTICE:
    Make sure that there is no damage such as scratch on the inner joint face of the crankshaft after the oil seal removal. If it is found, make the surface smooth by a sandpaper (#400).