Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › EXTENSION HOUSING REAR OIL SEAL

EXTENSION HOUSING REAR OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


    C103239E01
  1. Coat the lip of a oil seal with MP grease.

  1. Using SST and a hammer, drive in the new oil seal.

    SST
    09325-40010  



2. INSTALL PROPELLER SHAFT ASSEMBLY


    C102186E01
  1. Remove the SST from the extension housing.

  1. Install the propeller shaft assembly in the extension housing.

  1. Align the matchmarks on the propeller shaft flange and differential flange.



    C102185E01
  1. Install the propeller shaft assembly with the 4 nuts, 4 bolts and 4 washers.

    Torque:
    74 N*m{ 755 kgf*cm , 54 ft.*lbf }



3. ADD AUTOMATIC TRANSMISSION FLUID


4. INSPECT AUTOMATIC TRANSMISSION FLUID

HINT:
Drive the vehicle so that the engine and transmission are at normal operating temperature.

Fluid temperature:
70 to 80 °C (158 to 176 °F)



    D025120E01
  1. Park the vehicle on a level surface and set the parking brake.

  1. With the engine idling and the brake pedal depressed, move shift the lever into all positions from P to L and return to the P position.

  1. Take out the dipstick and wipe it clean.

  1. Put it back all the way.

  1. Take it out again and check that the fluid level is within the HOT range.
    If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add the proper amount of new fluid and recheck the fluid level.