FRONT BRAKE FLEXIBLE HOSE > INSTALLATION |
| 1. INSTALL FRONT FLEXIBLE HOSE |
![]() |
Connect the front brake flexible hose with the union bolt and a new gasket.
Install the front brake flexible hose with a new clip.
Connect the brake tube to the front brake flexible hose with a SST while holding flexible hose with a wrench.
| 2. ADD BRAKE FLUID |
![]() |
| 3. BLEED BRAKE LINE |
Connect the vinyl tube to the bleeder plug.
Depress the brake pedal several times and loosen the bleeder plug with the pedal held down.
At the point where the fluid stops coming out, tighten the bleeder plug and release the brake pedal.
Repeat this procedure until the air in the brake fluid is completely bled out.
Tighten the bleeder plug.
Front bleeder plug:
Rear bleeder plug:
Repeat the above procedure to bleed the air out of the brake line for each wheel.
| 4. INSPECT BRAKE FLUID LEVEL IN RESERVOIR |
Check the fluid level and add fluid if necessary.
| 5. CHECK BRAKE FLUID LEAKAGE |
| 6. INSTALL FRONT WHEEL |