FRONT DOOR > ADJUSTMENT |
| 1. INSPECT FRONT DOOR |
Check that the clearance of areas A to D are within the standard range.

| Area | Measurement | Area | Measurement |
| A | 5.4 +- 1.5 mm (0.213 +- 0.059 in.) | C | 5.1 +- 1.5 mm (0.201 +- 0.059 in.) |
| B | 5.5 +- 1.5 mm (0.217 +- 0.059 in.) | D | 5.1 +- 1.5 mm (0.201 +- 0.059 in.) |
| 2. ADJUST FRONT DOOR |
Disconnect the cable from negative (-) battery terminal from the battery.
![]() |
Using SST, loosen the bolts on the pillar side to adjust the door front and back, up and down.
Loosen the bolts on the door side to adjust the door up and down, and the door front side to side.
![]() |
When adjusting the door rear side to side, and the front door lock striker plate assembly, use a "torx" socket wrench (T40) to loosen the "torx" screws until the striker can move. Lightly tap it with a brass bar for adjustment.
Connect the negative (-) terminal cable to the battery.
Initialize both systems.
Inspect the SRS warning light.